INTORQ BFK470 Series, Translation Of The Original Operating Instructions

Page: 22 / 52

Mechanical installation
INTORQ | BA 14.0199 | 08/2016 22
4.2 Assembly
4.2.1 Preparation
1. Unpack the spring-applied brake.
2. Check for completeness.
3. Verify the nameplate data (especially the rated voltage).
4.2.2 Brake assembly
Installation of the hub onto the shaft
Abb. 4 Installing the hub onto the shaft
1. Press the hub with a moderate amount of force to the shaft.
NOTICE
The toothed hub and screws must not be lubricated with grease or oil.
NOTICE
The customer is responsible for constructing the shaft-hub connection. Make sure that the
bearing length of the key is identical to the length of the hub.
NOTICE
Check the tensile strength of the hub material: When operating with high torque, consult with
INTORQ and use a steel hub with a higher tensile strength.
A Circlip B Hub C Keyway
D End shield