Mechanical installation
INTORQ | BA 14.0215 | 07/2019
34
Fig. 19:
Final installation of the hand-release
A
Self-locking nut
B
Clip
C
Tension rod
D
Second complete stator
E
First complete stator
F
End shield
G
Self-locking nut
H
Rotor
5. Attach the clips with the bore holes (Ø 9 mm) to the tension rods and tighten them with the lock nuts.
The blind holes (Ø 17 mm) are now pointing in the direction of the stator and the screw heads of the
hand-release levers are completely sunk into the clips.
6. Position the second stator in front of the first complete stator. Insert the pre-assembled tension rods
into the through holes (Ø 9 mm) of the first complete stator.
NOTICE
Make sure that the tension rods are not bent!
