Mechanical installation
INTORQ | BA 14.0215 | 07/2019
22
5
Mechanical installation
This chapter provides step-by-step instructions for the installation.
Important notes
NOTICE
¾
The gear teeth and screws must not be lubricated with grease or oil.
¾
Do not change the optional factory coating on the gear teeth.
Notice
The two "complete stators" of a brake are delivered in pairs. One of the two stators has the
name plate for the complete brake and, when necessary, additional attachments.
This stator must be mounted as a second stator.
5.1
Design of end shield and shaft
¾
Comply with the specified minimum requirements regarding the end shield and the shaft to ensure a
correct function of the brake.
¾
The diameter of the shaft shoulder must not be greater than the tooth root diameter of the hub.
¾
The form and position tolerances apply only to the materials mentioned. Consult with INTORQ before
using other materials; INTORQ's written confirmation is required for such usage.
¾
It may be necessary to use a flange as a counter friction surface.
¾
The brake flange must be supported by the end shield across the full surface.
¾
Depending on the type of installation, additional clearing bore holes may be required.
¾
Keep the end shield free from grease or oil.
Minimum requirements of the end shield
Size
Material
1)
Roughness
Run-out
Levelness
[mm]
[mm]
25
S235JR; C15;
EN-GJL-250
Rz6
0.1
< 0.1
Tab. 5:
End shield as counter friction surface
1)
Consult with INTORQ before using other materials.
