347
A
S AVE THESE INSTRUCTIONS
(347IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/08/2020
English
Page 14
SET UP (continued)
Spa Control unit Installation
1.
Connect the spa control unit to the spa tub
(see drawing 9)
. Hand-tighten the connectors securely.
Do not use tools to tighten.
NOTE:
Never attach external accessories not supplied with the kit to the spa tub or control base unit, as
this will void the warranty.
2.
Replace the control base side covers
(4)
(see drawing 10)
.
CAuTION:
Do not sit, lean, cover or place any objects over the spa control unit.
3.
Attach the filter cartridge housing assembly to the inside of the spa
tub outlet grid (lower position)
(see drawing 11)
.
Inflate the spa tub
first before installing filter pump fittings.
4.
Before filling with water ensure the bottom drain valve caps are
securely closed on the inside and outside.
5.
Fill the spa tub with freshwater to a level between MIN and MAX
marked on the inside of the spa wall. Do not over fill the spa.
Never move the spa tub with water inside and/or with the control
base attached to the spa as the spa or control base may be
damaged.
WARNING:
Never pour water with a temperature higher than
40°C (104°F) into the spa directly. It is recommended to fill the
spa tub with lukewarm water for quick heating and energy saving.
6.
Place the spa cover and spa air bladder (pre-installed in spa cover)
over the spa tub, and make sure the spa cover buckles are locked
using the key provided after pulling the buckled straps tight.
IMPORTANT:
Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
7.
Ensure that the spa base is plugged into a properly located and sized electrical outlet and press the
button to turn on the control panel. Press the
button on the control panel to activate the heater, see “Spa
Control Panel” operation section.
Spa Cover
The attachment buckles of the cover are locking buckles. Two keys are provided in the plastic bag with the
manual and other accessories. Each buckle is marked with “locked” and “unlocked” symbols for easy operation:
put the key into the slot on the buckle and turn it to the appropriate position to lock or unlock the buckle
respectively.
To assure safety from unauthorized access, always put the cover on when spa is not in use and lock all
buckles. Always keep the keys out of reach of children. In case you misplace the keys, you can use any similar
size flat screwdriver to lock or unlock the buckles.
When the spa is being used, the cover should be placed in a clean, dry area, otherwise it can pick up dirt and
bacteria. Covers should not be put on wooden tables or wooden decking because of the risk of bleaching the
wood. A cover lifter, dedicated support or similar device, is recommended for ensuring that the cover, mostly its
side facing the water, does not come into contact with the ground or any other dirty surfaces.
10
9
11
