![background image](http://html.mh-extra.com/html/intex/purespa-sb-h20/purespa-sb-h20_owners-manual_2081124023.webp)
347
A
S AVE THESE INSTRUCTIONS
(347IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/08/2020
English
Page 23
TROUBLESHOOTINg
PROBLEM
CAuSE
SOLuTION
NO DISPLAY/SPA
CONTROL UNIT
DOES NOT WORK
• Spa is unplugged or off.
• Control panel cable plug loose.
• Power failure.
• RCD tripped.
• RCD broken.
• Ensure the spa is plugged and switched on.
• Ensure the control panel cable plug is firmly
attached to the control base receptacle.
• Check power source.
• Reset the RCD.
• Contact Intex Service Center.
HOUSEHOLD
CIRCUIT BREAKER
TRIPPED
• Circuit breaker under rated.
• Overloaded circuit breaker.
• An electrical fault in the line.
• Ensure correct circuit breaker rating.
• Provide a dedicated circuit breaker feeding the
spa electrical outlet only.
• Contact a qualify electrician to correct the
electrical fault.
NOT HEATING
PROPERLY
• Temperature set too low.
• Dirty filter cartridge.
• Water temperature decreasing during
heater STANDBY mode.
• Heating element failed.
• Increase the temperature and attach the spa
cover.
• Clean or replace the filter cartridge in time.
• If heater is in STANDBY mode, press the flame
button twice to heat up the water to the set
temperature.
• Contact Intex Service Center.
BUBBLE AIR
BLOWER DOES
NOT WORK
• Air blower pump is too hot.
• Turn off and unplug the spa. Let it cool down and
restart all over again.
• If problem persists, contact Intex Service Center.
FILTRATION PUMP
NOT WORKING
• Dirty filter cartridge.
• Filtration inlet and/or outlet clogged.
• Filter pump motor failed.
• Clean or replace the filter cartridge in time.
• Check and clean filtration inlet and outlet
regularly.
• Contact Intex Service Center.
WATER NOT CLEAN • Cartridge assembly not properly
attached.
• Insufficient filtering time.
• Dirty filter cartridge.
• Improper water maintenance.
• Filtration inlet and outlet clogged.
• Ensure the cartridge assembly is properly
attached.
• Increase filtration time.
• Clean or replace the filter cartridge in time.
• Keep the spa water properly sanitized. Refer to
the chemical manufacturer’s instructions.
• Check and clean filtration inlet and outlet
regularly.
PUMP
CONNECTORS
ARE NOT LEVEL
WITH THE SPA
CONNECTORS
• One characteristic of PVC is that it
changes shape, which is normal.
• Elevate the pump with wood or another type of
insulated material to bring the pump’s connectors
level with the spa’s connectors.
TUB HAS A
STRANGE SHAPE
• Expanded internal air pressure by
strong sunshine.
• Do not expose the spa to direct sunlight for
extended period of time.
• Check the air pressure and release air if
necessary. During very hot weather, you must
check to see whether it is necessary to release
some air. This is to avoid any possible damage
to the tub.