81PO
English
(81PO) HAPPY CRAB EASY SET POOL ENGLISH 4.875” X 7.25” 07/13/2020
S AVE THESE INSTRUCTIONS
Page 12
Proper inflation of the top ring.
The ambient temperatures of air and water have an effect on the internal pressure of the top
ring. To maintain a correct internal pressure, it is best to leave some room for expansion as
the sun heats the air inside the ring. During very hot weather, you must check to see
whether it is necessary to release some air. This is to avoid any possible
damage to the ring.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the inflatable top ring caused by negligence, ordinary wear and
tear, abuse and carelessness, or external forces.
3. Hose connectors
•
If the pool was purchased
without
a filter pump, insert two black plugs
(2)
into the black
filter pump outlets. Do this from the inside of the pool so that water will not run out when
filling it.
• If the pool was purchased
with
a filter pump, read the Krystal Clear™ Filter Pump Manual
first and
then
proceed to next installation step.
4. Filling of the pool
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and
that the drain cap on the outside is screwed on tightly. Fill the pool with no more than
1 inch of water. Check to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely
level. Setting up the pool on unleveled ground will cause the pool to tilt resulting in
the sidewall material to bulge and a potential collapse of the pool. If the pool is not
completely level, you must drain the pool, level the area and re-fill the pool.
• Smooth out the bottom liner wrinkles (from
inside the pool) by pushing out where the pool
floor and pool sides meet. Or, (from outside the
pool) reach under the side of the pool, grasp the
pool floor and pull in an outward direction. If the
ground cloth is causing the trouble, have 2 adults
pull from opposite sides to remove all wrinkles
(see drawing 4)
.
• Now fill the pool with water. The pool liner walls
will rise while you are filling it
(see drawing 5)
.
• Fill the pool with water up to the bottom of the
inflated ring which is the recommended fill line
level
(see drawing 1).
POOL SETUP (continued)
IMPORTANT
4
5
