81PO
English
(81PO) HAPPY CRAB EASY SET POOL ENGLISH 4.875” X 7.25” 07/13/2020
S AVE THESE INSTRUCTIONS
Page 11
You may have purchased this pool with the Intex Krystal Clear™ filter pump. The pump
has its own separate set of installation instructions. First assemble your pool unit and then
set up the filter pump.
Estimated assembly time 10~30 minutes. (Note the assembly time is only approximate and
individual assembly experience may vary.)
1. Liner preparation
•
Find a flat, level location that is free and clear of stones, branches or other sharp objects
that may puncture the pool liner or cause injury.
• Open the carton containing the liner, etc., very carefully as this carton can be used to
store the pool during the winter months or when not in use.
• Take out the liner
(1)
and spread it over the
cleared area, with the drain valve directed
towards the draining area. Place the drain valve
away from the house.
IMPORTANT: Always set up the pool unit
with at least 2 persons. Do not drag the liner
across the ground as this can cause liner
damage and pool leakage (see drawing 2).
• During the setup of the pool liner, point the hose
connections or openings in the direction of the
electrical power source. The outer edge of the
pool should be within reach of the pump’s
electrical connection.
• Lay out the pool. Spread out the plain blue sides
and make the pool floor as smooth as possible
(see drawing 2).
2. Ring inflation
• Flip the top ring out and check that it is fully
outside of the wall lining and facing up. Inflate
the ring with a manual air pump
(see drawing 3)
.
Keep the top ring centered in the middle of the
pool, while doing this. Other features may need
to be inflated through a separate inflation valve.
IMPORTANT: Prevent bursting by not using
a high-pressure pump, such as an air
compressor. Do not over inflate. Preferably
use an Intex manual inflation hand pump
(not included).
POOL SETUP (continued)
1
WATER
LEVEL
Level
FILL LINE
2
3
