background image

243

PO

(243PO)  MULTIFUNCTION FLOATING POOL LIGHT  ENGLISH  7.25” X 4.875”  05/21/2013

SAVE THESE INSTRUCTIONS

•  For adult use only. This product is not a toy, keep away from children.

•  Do not stare directly at the light emitted by this product.

•  This product is resistant to water, but it is not designed to be completely submerged. Submersion could cause water to 

  enter the product causing damage to the electronics.

•  Do not replace the batteries while in the pool.

•  Do not sit, straddle, or step on the product.

FOLLOW THESE RULES AND ALL INSTRUCTIONS TO AVOID INJURY OR PROPERTY DAMAGE.

Page 1

READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT  

INTEX

®

 OWNER'S MANUAL

LED FLOATING POOL LIGHT    Model FL690

General Information and Maintenance Instructions:

•  Best for pools up to 18 feet (549cm) in diameter.

•  This product operates on four (4) AAA size batteries (not included).

•  Alkaline batteries are recommended. Rechargeable batteries are okay to use.

•  Remove batteries if light is not to be used for an extended period of time.

•  Do not mix old and new batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel -  Cadmium) 

  batteries.

•  Dry any water on the product prior to battery installation. Remove used batteries promptly. Replace all 4 batteries at 

  the same time.

•  Always purchase the correct size and grade of battery most suitable for the intended use. Ensure batteries are installed 

  correctly with regard to polarity (+ and -). Clean the battery contacts and also those of the device prior to battery 

  installation.

•  To clean the product, use only a damp cloth. Avoid strong cleaner, excessive water and abrasive brush. 

243-*PO-R0-1407

WARNING

Summary of Contents for FL690

Page 1: ...tion and Maintenance Instructions Best for pools up to 18 feet 549cm in diameter This product operates on four 4 AAA size batteries not included Alkaline batteries are recommended Rechargeable batteries are okay to use Remove batteries if light is not to be used for an extended period of time Do not mix old and new batteries Do not mix alkaline standard Carbon Zinc or rechargeable Nickel Cadmium b...

Page 2: ...ter clockwise direction see Fig 1 2 Insert 4 AAA size batteries following the orientation shown on the battery holder see Fig 2 3 Reinstall the battery housing by aligning the groove on the battery housing with the ridge on the light body see Fig 3 4 Using a clockwise motion securely tighten the battery housing by hand only see Fig 4 1 2 3 Fig 1 Fig 2 Due to a policy of continuous product improvem...

Page 3: ...A batteries are installed correctly with regard to polarity and 2 Check that the battery housing is snug hand tightened 3 Replace the batteries Q What should I do if the light emitted by this product is too weak A 1 Clean outside surface of the light housing using a soft damp cloth Note the light housing is an optical component to avoid any scratches do not use any hard or abrasive rag to clean it...

Page 4: ...ovisions of this Limited Warranty shall be brought before an informal dispute settlement board and unless and until the provisions of these paragraphs are carried forth no civil action may be instituted The methods and procedures of this settlement board shall be subject to the rules and regulations set forth by the Federal Trade Commission F T C IMPLIED WARRANTIES ARE LIMITED TO THE TERMS OF THIS...

Reviews: