(249IO) MODEL ECO7221/7231 Cartridge Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 04/13/2017
249A
SAVE THESE INSTRUCTIONS
English
Page 18
SALTWATER SYSTEM OPERATION (continued)
5
.
Boost cycle:
•
First time installation, press and hold “BOOST” button for 5 seconds until the
indicator lights up and the LED display “80”. This indicates that the saltwater
system has started more chlorine sanitizer production. You can press and
hold the “BOOST” button for another 5 seconds until the indicator is off,
which will cancel the Boost cycle.
•
The boost operating hours is 8 times the amount of time programmed into the
system, i.e. if your saltwater system operating time is 2 hours, the boost procedure will run
8 x 2 = 16 hours. After boost procedure has been completed, the system will automatically
switch to the normal working mode.
•
After a heavy rain or if the pool is dirty, press the “BOOST” button to shock the pool again.
6. Stand-by/power saving mode:
•
When the cycle ends, the green “SLEEP” indicator on the
control panel lights up and the LED display flashes “93”.
The system is now in Stand-By mode. After a while, it
shuts down and sets itself in a Power Saving mode. The
system will automatically turn itself back on in 24 hours,
starting its daily cycle of chlorine production.
•
The “SLEEP” indicator stays on, while the system is in the
Power Saving mode. The LED display however, goes blank
after 5 minutes. Press any button ( or ) to view the last
LED
code.
7. Running the pump alone without the Saltwater System:
To run the pump alone without the Saltwater System function,
press and hold both and buttons until you hear a “beep”,
the LED display will show “FP”. The pump is now operating
alone. NOTE: The pump cannot be operated alone under an
automatic timer mode. To stop the pump, manually turn
the switch OFF.
To bring back the initial automatic operating cycle setting
of the Saltwater System:
a) If the LED display shows “FP”, press the button and
the operating hours set previously will begin flashing,
press the button again or simply wait 1 minute, and
the LED will stay illuminated. The Saltwater System
cycle repeats again.
b) If the unit is OFF, turn the switch ON, the LED display
shows “FP”, press the button and the operating hours
set previously will begin flashing, press the button
again or simply wait 1 minute, and the LED will stay
illuminated. The Saltwater System cycle repeats again.
