![background image](http://html.mh-extra.com/html/intex/cs15220/cs15220_owners-manual_2081332009.webp)
241A
SAVE THESE INSTRUCTIONS
(241IO) SALTWATER SYSTEM & SAND FILTER PUMP (14” & 16”) ENGLISH 7.5” X 10.3” PANTONE 295U 08/09/2013
English
Page 9
4.
In a clockwise motion screw filter housing nut
(17)
onto the motor water inlet
(See
drawings 12.1 & 12.2)
.
5.
Replace the basket
(16)
and leaf trap cover
(14)
back to the pre-filter housing
(See
drawings 13.1 & 13.2)
.
SETUP INSTRUCTIONS (continued)
Sand tank installation:
1.
Place the tank support base at the selected location.
2.
Place the tank on the tank support base
(See drawing 14.1).
3.
Connect the motor pre-filtering assembly unit to the tank support base
(See drawing 14.2)
.
NOTE: Ensure the pre-filter housing water inlet hose connection is facing towards the pool.
IMPORTANT: Some countries, especially in the European community, require the
product to be secured to the ground or to a base in a permanent upright position.
Check your local authorities to determine if there is a regulation in your area
regarding above-the-ground swimming pool filter-pumps. If yes, then the product can
be mounted to a platform using the two holes located in the base. See drawing 14.3.
The product can be mounted on a cement base or onto a wooden platform to prevent
accidental falling over.
•
For model CS20220 & CS20230: The mounting holes are 6.4 mm in diameter and
spaced 115 mm apart.
For model CS15220 & CS15230: The mounting holes are 6.4 mm in diameter and
spaced 115 mm apart.
•
Use two bolts and lock nuts with a maximum of 6.4 mm in diameter.
13.1
13.2
14.1
14.2
14.3
16
14
12.2
12.1
17
17
41
Model CS20220 & CS20230:
115 mm
Model CS15220 & CS15230:
115 mm