27
JUNG® thermostats temperature control
This type of device is used for the JUNG® thermostats control, where it is not
allowed to modify the set-point temperature through the 2 bytes group address. By
the means of the 1Byte group address used, we get the same behavior than the
thermostat adjustment wheel.
The group addresses to configure are:
-
Modification entrance set-point 1Byte:
temperature’s base value.
-
Set-point temperature 2Byte:
temperatures visualization.
-
Modification set-point status 1Byte:
temperatures base value status.
For the correct functioning of the device, it is important to check that the reading flag
of the feedback in the ETS has been activated.
Summary of Contents for Houseinhand
Page 1: ...Configuration manual v2 5...