13
Force to Night Mode
The built-in ICR will be always disabled to allow all light input, color mode or
black/white mode can be selectable
Auto Mode (AE) Mode
Day or night mode will be decided by system analysis via entire captured image, user
can also adjust “From day to night” and “back to day” trigger level for specific
environment.
**A luminance measured value is displayed on UI real-time for adjust reference
External Trigger Mode
&an accept external light sensor trigger to switch day or night mode (eg. An
external light sensor equipping with IR LED can change ICR to night mode for IR
illumination at night time.
**The pin5 & pin6 can connect with external signal input by 5V / 0V high / low voltage
level
&an accept external alarm from external light sensor by VISCA
command to switch between day and night modes; the acceptable VISCA command,
please refer to Appendix “ICR Switch On/Off Alarm Receive” section.
Day Time Profile / Night Time Profile
User can independently define all image parameters on “Day Time Profile”and “Night
Time Profile”; the profile switching depends on Day/Night setting.
White Balance:
6upports white balance with following modes:
AWB (Auto White Balance)
This mode is automatically to compute white balance by system via color information
from captured image; B series performs the proper value using color temperature
radiating from a black subject based on a range of values from 2,800K to 10,000K
Manual WB Lock
This mode is to manually keep white balance at fixed value that is adjustable and
defined by the request of users with the white color definition (eg. User can shoot the
defined”white”full image, then push “Manual WB Lock”to enable this feature on UI).
