20 of 40
Version 1.2 (08/2022) en
Translation of original operating instructions
Assembly and installation
6.2.2 Installation of Pallet Drive in mounting brackets
The mounting brackets must be sufficiently robust to withstand the motor torque.
1.
Install the brackets at the conveyor or machine frame. Ensure that the Pallet Drive is installed parallel to the
transport rollers and at a right angle to the conveyor belt frame.
2.
Ensure that at least 80% of the key surfaces of the Pallet Drive are held by the mounting brackets (cable side).
3.
Ensure that the distance between the key surfaces and the bracket is free from play.
4.
On the side without cable, use a screw M12; 8.8 and tighten with a tightening torque of 80 Nm.
The Pallet Drive can also be installed without mounting brackets. In this case, the shaft end of the cable side
must be installed in a corresponding recess in the conveyor belt frame; this recess must be designed in such
a way that the aforementioned requirements are met.
Axial play
1 Torque tension displacement
The entire axial clearance of the Pallet Drive should measure 1 mm minimum and 2 mm maximum.
Summary of Contents for DP 0080
Page 1: ...INSPIRED BY EFFICIENCY User Manual Interroll Pallet Drive DP 0080 DP 0089...
Page 38: ...38 of 40 Version 1 2 08 2022 en Translation of original operating instructions Appendix...
Page 39: ...Version 1 2 08 2022 en Translation of original operating instructions 39 of 40...
Page 40: ...INSPIREDBY EFFICIENCY 2022 INTERROLL EN 08 2022 Version 1 2...