KNX IP Router
Product Manual
22
@2019 INTERRA
PM190205012AEN
PARAMETER
DESCRIPTION
VALUES
Physical telegrams :
Repetition if errors on
subline
After subline transmission error(e.g. due to
missing receiver) Physical telegrams :
no : Are not repeated.
up to 3 repetitions : Are repeated max. 3 times.
one repetition : Are repeated once.
no
up to 3 repetitions
one repetition
Group telegrams :
Repetition if errors on
subline
After subline transmission error(e.g. due to
missing receiver) Group telegrams :
no : Are not repeated.
up to 3 repetitions : Are repeated max. 3 times.
one repetition : Are repeated once.
no
up to 3 repetitions
one repetition
Telegram confirmation on
subline
if routed : Routed telegrams to IP main line are
confirmed by an ACK on the subline.
always : Each telegram on the subline is
confirmed by an ACK.
if routed
always
Send confirmation on own
telegrams
yes : Telegrams sent out to the subline are
confirmed by added ACK.
no : No ACK confirmation.
yes
no
Configuration from subline
(KNX TP)
If blocked an ETS download to the device can
occur only via IP main line.
allow
block
5.) WEB FRONT-END
The Web front-
end can be used to readout MECip´s actual device parameters (HTTP port, IP address, MAC address, …),
to update its firmware and to adjust the (additional) tunnelling addresses. To identify a particular ITR901-001 of a KNX
network the Programming LED/Program Mode can be remotely switched on without pressing the Program Button.
Note: To switch back from Boot Mode to normal operation it is necessary to run the firmware update procedure.
5.1) Accessing the Device Web Front-End
There are three ways to access the Interra KNX IP Router. It can be accessed like a Microsoft Windows UPnP network
device (Windows7 or later) and by a web browser. For access by a web browser either the IP address or the MAC address,
together with the HTTP port, have to be know
n. How to use IP address and MAC address with the browser´s URL bar is
described in the following.
Not 1: For access via web browser the HTTP port that is set by ETS (or the factory default parameter value) has to be used.
Not 2: ITR901-001 is able to use both official HTTP system ports (80 and 8080).
Not 3: Factory default HTTP port is 8080.
