KNX IP Router
Product Manual
14
@2019 INTERRA
PM190205012AEN
3.4) Programming
To download the desired physical address or an ETS setting the Program Button must be pressed first. Successive pressing
the Program Button will turn on and off the Program Mode. LED 7 lighting in red colour indicates Program Mode is active.
When Program Mode is active ETS recognizes the device of interest for downloading.
Not: A blinking red Programming LED indicates that the Ethernet cable is not connected properly.
Not: Even when Boot Mode is active successive pressing the Program Button will turn on and off Program Mode and
Programming LED.
3.4.1) Physical Address Assignment
To commission the ITR901-001 Interra KNX IP Router device an interface connection (IP, USB) to the KNX bus system is
required. The device is supplied with the individual physical address 15.15.0. The KNX product database entry(available for
ETS4 and higher) can be downloaded from the Interra web site and from the KNX Online Catalog.
With the ETS the physical address can be assigned to the device by setting the desired address in the properties window of
the ETS. After starting the ETS download and then pressing the Program Button the device restarts itself.
Fig 4: ETS Properties Window
Note:
The term “physical address” means the KNX physical address as well as the ETS individual address. Both terms are
used by the KNX organisation interchangeably.
