Intermec EasyCoder PL-Series, Programmer'S Reference Manual

Page: 91 / 220

Chapter 8— Advanced Commands
EasyCoder PL-Series Printer Programmer’s Reference Manual 73
{ delay-time }: Delay time in 0.125 second.
Example: In the example below, the printer pauses 10 seconds (10 x 8 = 80) after
printing each label.
Input (WAIT.LBL):
! 0 200 200 150 5
WAIT 80
TEXT 5 0 0 20 DELAY 10 SECONDS
FORM
PRINT
Speed Command
Purpose: You use this command to set the highest motor speed level. Each printer
model is programmed with a minimum and maximum attainable speed.
The Speed command selects a speed level on a scale of 0 to 5, level 0 being
the slowest within this range. The maximum speed programmed into each
printer model is attainable under ideal conditions. The battery or power-
supply voltage, stock thickness, print darkness, applicator usage, self-strip
usage, and label length can limit the maximum attainable print speed.
By exercising this command, you override the factory programmed speed
for the label being printed.
Format:
{ command } { speed level }
where:
{command}: SPEED
{speed level}: A number between 0 and 5, 0 being the slowest speed.
Example:
Input (SPEED.LBL):
! 0 200 200 150 1
SPEED 4
TEXT 5 0 0 20 PRINTS AT SPEED 4
FORM
PRINT
SETSP Command
Purpose: You use the SETSP command to change spacing between text characters.
Format:
{ command } { spacing }
where:
{command}: SETSP
{spacing}: Unit measurement between characters. The default for
spacing is zero. Range is 0 to 255.