Intermec EasyCoder PD42, User Manual

Page: 123 / 126

Appendix D — Setup Parameters (IPL)
EasyCoder PD42 Printer User’s Guide 113
Cutter (option)
Once a cutter has been installed in the printer, it must also be
enabled in the firmware. IPL commands are used to enable/
disable the cutter in configuration mode:
<STX>R<ETX>
Enter print/configuration mode
<STX><SI>c1<ETX>
Enable cutter
<STX><SI>c0<ETX>
Disable cutter
Network Setup
Please refer to the EasyLAN User’s Guide (P/N 1-960590-xx) for
information on the network setup parameters.
Returning to Factory Default Setup
You can restore all the printer’s default settings in Extended
testmode (see
page 36 ), or by using the Factory Default Wizard
in PrintSet 4.