13. Select the position to install the new relay module board.
14. Remove the two screws opposite of the filler panel screws. Set aside the screws for installation.
15. Bend the filler at the serration line until it breaks and remove and discard the filler.
16. Remove the outer two screws that secure the filler panel on the new relay module board. Set aside the screws for
installation.
17. Insert the new relay board module onto the chosen position of the electronic control panel using the mounting holes
positioned over the holes from where the screws have been removed
18. Make sure there are no wires under the board. Secure the relay board to the mounting bracket with the previously
removed screws.
19. Connect the relay module cable connector plug to the applicable connector on the door assembly. Make sure the
plug latches.
20. Connect the circuit wires to the applicable connector plug on the relay board.
21. Close the door assembly and secure with the same screw that was removed.
22. Reinstall the deadfront and secure with the same screws that were removed
23. Close the enclosure cabinet door.
24. Apply power to the unit.
INTERMATIC INCORPORATED
SPRING GROVE, ILLINOIS 60081
www.intermatic.com
Figure 4. Removing the relay module board.
Terminal Connector
Timer Controller
Door Assembly
8. On the inside of the door assembly, remove the circuit wires from the applicable terminal connector(s) on the relay
board.
9. Disconnect the relay module cable connector plug from the applicable relay module connector on the door assembly.
See Figure 4 for location of the relay module cable connector plugs.
10. Remove the screws that secure the relay module board to the mounting bracket and remove the board.
Retain the screws.
11. Dispose of the old relay module board.
12. Go to step 17.
If you are...
Then...
Replacing a Relay Module
Go to step 8
Installing or updating a new Relay Module
Go to step 13
LIMITED ONE-YEAR WARRANTY
If within the warranty period specified, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge.
This warranty is extended to the original household purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse
in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance
with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED’s and batteries; (f) the finish on any portion of the product, such as surface
and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs.
INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR
IMPLIED WARRANTIES. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE
HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME
STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased or (b) completing a warranty claim online at www.intermatic.com. This warranty is
made by: Intermatic Incorporated, Customer Service 7777 Winn Rd., Spring Grove, Illinois 60081-9698. For warranty service go to: http://www.Intermatic.com or call 815-675-7000.
7. After adjusting the jumpers to fit your output requirements take one of these actions:
