Installation Step 4
To finish installing the doorbell camera:
1. Route the cables and insert the cables and
power connector into the wall.
2. Align the screw holes on the doorbell body with
the drilled holes, wall anchors, or angle bracket.
3. Mount the doorbell body to the wall or angle
bracket using the two screws provided.
4. Affix the faceplate to the doorbell body using the
security screw and security screw wrench
provided.
5. Turn the power supply to the doorbell camera
back on and proceed to “Getting started” on page
12.
1. Wall screws
2. Security screw
To remove a mounted faceplate:
1. Remove the security screw using the wrench
provided.
2. Place both thumbs on top of the faceplate and
your fingers on the bottom of the faceplate.
P/N 466-2950-EN • REV B • ISS 07MAY18 © 2018 United Technologies Corporation. All rights reserved.
11
