Interlogix NXG-4, Installation And Programming Manual, Page: 145 / 170

xGen Lite Installation and Programming Guide 133
Then we click to Event List 2 and enter the name
“Informational”. Tick Opening
and Closing, and Autotest Report.
Programming Instructions for Channels
Goal
Set up communication paths and destinations for delivering event messages.
Pre-conditions
Communicator must be programmed (see
“Programming Instructions for
Communicator
” on page 126).
Event Lists must be programmed (see
“Programming Instructions for Event Lists”
on page 131).
Notes
Area Account Number will take priority over Account Number entered here for
Zone events. If no Area Account Number is entered then this number will be
used instead.
Next Channel must be a higher value than the current Channel Number. Circular
loops are not permitted.
Take note of the Sequence Attempts under Communicator > System Event
Reporting (6.11.2). This is the number of times xGenLite will attempt the
sequence of Channels you set up in this section.
Channel set up for push notifications is automatically performed by the
Ul app when required. The panel will assign the next available channel
and matching event list number. No configuration via the web pages or DLX900
is required.
Event
System / Area
Channel Group 1
Channel Group 1
Channel 1
Channel 4
Channel 6
Menu 6.11.1.1 or 4
Event sent to
Channel Group
Menu 18 – Channel Groups
Menu 5 – Channels Menu 17 – Event Lists
Each channel checks to
see if the event is on its
Event List, if yes it will
attempt to send, if not
then it stops.
Channel Group sends event
to
Channel it contains every
Channel 1
Control Room 1
Channel 4
Control Room 2
Channel 6
Email
Event List 1
Critical
Event List 2
Informational
Event List = 1
Event List = 1
Event List = 2
Alarms
Bypass & Restore
AC Fail
Open & Closes
Autotest