Chapter 4: Commands for CLI configuration
222
NS4750-24S-4T-4X-V2 Managed Switch Command Guide
Switch access-list rate limiter ID 8 is 1 pps
Switch access-list rate limiter ID 9 is 1 pps
Switch access-list rate limiter ID 10 is 1 pps
Switch access-list rate limiter ID 11 is 1 pps
Switch access-list rate limiter ID 12 is 1 pps
Switch access-list rate limiter ID 13 is 1 pps
Switch access-list rate limiter ID 14 is 1 pps
Switch access-list rate limiter ID 15 is 1 pps
Switch access-list rate limiter ID 16 is 1 pps
GigabitEthernet 1/1 :
GigabitEthernet 1/1 access-list action is permit
GigabitEthernet 1/1 access-list policy ID is 0
GigabitEthernet 1/1 access-list rate limiter ID is disabled
GigabitEthernet 1/1 access-list redirect is disabled
GigabitEthernet 1/1 access-list logging is disabled
GigabitEthernet 1/1 access-list shutdown is disabled
GigabitEthernet 1/1 access-list port-state is enabled
GigabitEthernet 1/1 access-list counter is 0
show access-list ace-status
Command:
show access-list ace-status [ static ] [ link-oam ] [ loop-
protect ] [ dhcp ] [ ptp ] [ upnp ] [ arp-inspection ] [ mep ]
[ ipmc ] [ ip-source-guard ] [ ip-mgmt ] [ conflicts ] [ switch
<switch_list> ]
show
Show running system information
access-list
Access list
arp-inspection
The ACEs that are configured by ARP Inspection module
conflicts
The ACEs that did not get applied to the hardware due to hardware
limitations
dhcp
The ACEs that are configured by DHCP module
ip-source-guard
The ACEs that are configured by IP Source Guard module
ipmc
The ACEs that are configured by IPMC module
link-oam
The ACEs that are configured by Link OAM module
loop-protect
The ACEs that are configured by Loop Protect module
mep
The ACEs that are configured by MEP module
ptp
The ACEs that are configured by PTP module
static
The ACEs that are configured by users manually
upnp
The ACEs that are configured by UPnP module
Default:
N/A
Usage Guide:
To display the
ACE Status.
Example:
To display the
ACE Status.
