4 / 6
P/N 1073029-EN
• REV
A
• ISS
03JUN15
Surface-mount camera
The cables of PTZ camera
can be rou
ted either from the top or
the side o
f the
housing.
For the cables routed from the top of
the housing,
you must
drill a cable hole in the ceiling.
1. Use the
mounting
base
as a template to mark four
screw
holes onto the ceiling.
If you route
cables
from the top of
the housing
, mark the cable
hole on the ceiling and drill a
hole.
Cable hole
Screw holes
2.
Secure the mounting base to the ceiling with
the set
screws.
3.
Unscrew
the bubble
from the camera and remove the
protective tape from the PTZ module.
4.
Press the two tabs on either side of the PTZ module and
remove it from the camera housing.
5.
Route the cables from the bracket and connect them
to
the PCB of the module through the cable entry hole on
the
top or side
of the housing
.
Note
:
If alarm
and audio input/output
relays are to be
used,
also connect them to the PCB of the module.
6.
Install the
housing on
to the mounting base.
Line up the
direction of
the
arrow
on the housing
with the spring end of
the mounting base.
Push the housing
upwards
(A) and
then forwards
(B)
in the direction of
the
arrow.
When the
housing
is placed in position, the spring will
automatically
snap into the lock clip
firmly
.
Refer to the
figures below
.
Line up
B. Push forward
A. Push
upward
Lock clip
7.
Insert the PTZ module into the housing:
8.
Re
-attach the bubble
by screwing it
to the housing.
Warning
: After installation, the PTZ module will perform a
PTZ self
-
test and initializes with the power on. DO NOT
touch and move the camera while it is self
-testing and
initializing.
9.
See “Accessing the camera over the internet
”
below
to
configure the camera over the internet. Refer to the
Configuration Manual for detailed information.
Using the camera with an Interlogix NVR or
Hybrid DVR or another system
Please refer to the
NVR/DVR user manuals for i
nstructions on
connecting and operating the camera with these systems.
Using the camera with TruVision Navigator
A camera must be connected to an Interlogix NVR or hybrid
DVR
to be operated by TruVision Navigator. Please refer to the
TruVision Navigator user manual for instructions on operating
the camera with the TruVision Navigator.
Accessing the camera over the
internet
Use the web browser to access and control the camera over
the internet.
Note
:
Any changes made to the camera’s configuration only
apply to this camera.
