4
NOTE
Proper placement of the cover depends on the brackets, so do not tighten the back bracket
fully in case you need to adjust it to make the cover fit.
8. Place the cover over the chassis. There are two slots, or notches, at the bottom of each
side of the tower cover front; these fit around the flange on the bottom front of the
chassis. Also, there is a cutout on the inside of the cover at the front and the back.
Make sure that the front and rear brackets fit inside these cutouts.
NOTE
At this point, you may need to adjust the rear bracket to ensure that the cover fits properly.
9. Finish tightening the rear bracket screws you inserted in step 7 so that they are fully
countersunk.
10. Turn the unit upside down again, and use six M5 countersunk screws to secure the cover
to the unit.
11. Turn the unit right side up again.
Installing the Fibre Channel Storage System Components
Now that you have installed the tower foot and cover, you can install all of the components
in the Fibre Channel chassis. The SS-1200-FCAL Rack Installation and User Guide
describes each of the components of the storage system in detail. Installation of these
components is described for a rack-mount system; for example, the slots are referred to in
terms of left to right instead of top to bottom as in a tower configuration. The following
illustration shows the unit in the tower position with the slots labeled accordingly.
