Intergraph DHAF02430, System Reference Manual

Page: 17 / 98

7
3. Remove the four screws securing the drive to the drive bay as shown in the following figure.
4. Set the SCSI ID on a new SCSI drive to the same ID as the old drive. On a new EIDE drive, set
the mode select header to “master.” Refer to Chapter 9, “Peripherals,” for details.
5. Attach the new drive to the horizontal bay and attach it to the base unit. Connect the power
cable, data cable, and audio cable. Ensure the stripe on the data cable is oriented correctly.
6. Close the base unit.
Screws (Two
each side)