Intergraph DHAF02430, System Reference Manual

Page: 37 / 98

27
bar away from the heat sink fins. The support assembly is permanently connected to the system
board, and need not be removed.
3. Remove the Pentium Pro processor module. Grasp both tabs on the top corners of the processor
module and press them inward, towards each other. Then pull the entire module upward,
keeping the tabs pressed inward. Heat sinks are permanently connected to the module, and need
not be removed.
4. Remove the voltage jumper from J19, and place it on jumper J39. Refer to the following figure.
Also refer to Chapter 6, “System Board MSMT378,” for details on jumper settings.
5. Install the heat sink support assembly to the system board. The assembly snaps into place in two
of the indicated holes. Refer to the following figure.
J39
J19
J34
J33
J23 J24
J49
J50
J47
J48
CPU
Frequency
Socket for CPU 1
CPU 0
SCSI
Host Bus
Frequency
Clock
Voltage
Host Bus
Frequency
J33, J34
Clock Voltage
J39
Holes for Heat
Sink Supports
6. Reinstall the ISA cards and close the base unit.