16 Ga. Medium Crown Stapler
Drives 7/16" Crown Staples (1" to 2" / 25 to 51mm)
Model No. SN5016
Item No. 64405
13
Interchange Brands
Operator’s Manual
When loading staples into Stapler
■
Do not pull trigger
■
Do not depress safety/push lever
■
Keep stapler pointed downward
1 .
Pull the staple feeder backward and
attach it securely to a groove of the
magazine .
2 .
Place the staple strip over the
magazine . Make sure that the staple
strip slides freely on the magazine .
3 .
Pull the staple feeder backward .
The, detach it from the groove
of magazine and softly bring the
staple back as if it were being gently
pushed, avoiding any impact .
4 .
The stapler is now ready to operate .
Staple Loading
!
WARNING
NEVER connect stapler to pressure which potentially
exceeds 150psi.
NEVER USE NON-RELIEVING COUPLER ON STAPLER.
The stapler and air hose must have a hose coupler so that
all pressure is removed from the stapler when the coupler is
disconnected . The connector on the tool must not hold pressure
when the air supply is disconnected . If the wrong fitting is
used, the tool can remain charged with air after disconnecting
and thus will be able to drive a staple even after the air line is
disconnected, possibly causing injury .
DANGER
NEVER use oxygen or other bottled gases, as an
explosion may occur.
!
!
CAUTION
If the staple feeder is suddenly
released, it can return abruptly,
causing deformation and/or scatter,
eventually ending up in clogged
staples.
Be sure to bring back the staple
feeder, avoiding any impact.
