16 Ga. Medium Crown Stapler
Drives 7/16" Crown Staples (1" to 2" / 25 to 51mm)
Model No. SN5016
Item No. 64405
14
Interchange Brands
Operator’s Manual
Testing The Stapler
Before using the stapler, test it by using the check list below . Conduct the test in
the following order . If abnormal tests occur, stop using the stapler and contact an
authorized service center immediately .
1 .
Disconnect air hose from stapler .
Remove all staples from stapler .
ALL SCREWS MUST BE TIGHTENED.
If any screws are loose, tighten them .
THE SAFETY/PUSH LEVER AND
TRIGGER MUST MOVE SMOOTHLY.
2 .
Adjust the air pressure to 70psi .
Connect the air hose .
Do not load any staples in the
stapler .
THE STAPLER MUST NOT LEAK AIR.
Hold the stapler downward and pull
the trigger .
THE STAPLER MUST NOT LEAK AIR.
3 .
Remove the finger from the trigger
and press the safety/push lever
against the wood .
THE STAPLER MUST NOT OPERATE.
4 .
Without touching the trigger, depress
the safety/push lever against the
work piece .
Pull the trigger .
THE STAPLER MUST OPERATE.
5 .
With the stapler off of the work
piece, pull the trigger . Depress the
push lever against the work piece .
THE STAPLER MUST OPERATE.
6 .
If no abnormal operation is
observed, you may load staples in
the stapler .
Drive staples into a test piece that
is the same type to be used in the
actual application .
THE STAPLER MUST OPERATE
PROPERLY.
