6
Interchange Brands, LLC
Manual Carton Closing Staplers
Model No. SHB100-A
& SHB150-C
PROBLEM
CAUSE
REMEDY
Excessive Jams
Teeth screws loose.
Staple size is wrong.
Tighten screws.
Use the proper size staple.
Uneven Clinch
Wrong staple size
Check for proper length
adjustment and clincher size.
Unclinched staple
Teeth are loose.
Teeth are broken.
Tighten teeth.
Replace teeth.
Can’t clinch staples well
Adjustment screw is
at wrong position.
See and check “Clinch Adjustment”
(page 5).
Operating Instructions
Operating the Tool
1.
Insert staples into your tool following the instructions on
page 4 of this manual .
2.
Position the box in line with the desired staple location,
using the small projections on either side of the magazine
seat to aid in locating the position of the staple .
3.
Hold the handle with your hand and press the handle
all the way down until it stops by the other hand .
Release the handle and move the stapler to the next
location .
4.
To achieve the strongest closure, place staples near the end
of box, but check the packing requirements to find optimal
staple placement .
5.
Test staple clinching in samples of the box board being
used . Make adjustments for depth of penetration and
tightness of clinch as needed .
WARNING:
To prevent accidental injuries: never place a hand or any other part of body in
staple clinching area or adjustment window . Never point tool toward anyone else . Do not engage
in horseplay . Always handle the tool with care . Never press handle unless tool is in positioned over
carton . Protect your eyes and ears . Wear safety glasses with side shields . Wear hearing protection .
Employers and users are responsible for ensuring the user or anyone near the tool wears this safety
protection .
NOTE:
Check and replace any damaged or worn components on the tool . The safety warning
labels on the tool must also be replaced if they are not legible .
WARNING:
Stop using the tool immediately if any of the following problems occur . Serious
personal injury could occur . A qualified person or an authorized service center must do any repairs or
replacements .
Trouble Shooting
3
1
4
