16 Ga. Wide Crown Stapler
Drives 15/16" Crown Staples (5/8" to 2" / 16 to 50mm)
Model No. SGSW5016
Item No. 64415
7
Interchange Brands
Operator’s Manual
10.
STAY ALERT.
Watch what you are doing . Use common sense and do not operate the stapler when
you are tired . The stapler should never be used if you are under the influence of
alcohol, drugs or medication that makes you drowsy .
11.
KEEp WORK AREA CLEAN.
Cluttered areas invite injuries . Clear all work areas of unnecessary tools, debris, etc .
12.
NEVER CARRY THE STApLER BY THE HOSE.
13.
HANDLE THE STApLER CAREFULLY.
This stapler was designed for driving staples into wood and similar items . Operate the
stapler safely and correctly and do not use for purposes other than those specified in
this manual .
Because of high air pressure in the stapler, cracks in the surface are dangerous . To
avoid tool damage, do not drop the stapler or strike the stapler against hard surfaces
and do not scratch or engrave on the stapler . Handle the stapler carefully .
14.
BEFORE USING THE STApLER, CHECK TO MAKE SURE pARTS ARE NOT
BROKEN OR MISSING AND THAT ALL SCREWS ARE TIGHT. DO NOT
OpERATE A TOOL THAT IS OpERATING ABNORMALLY.
If the stapler appears to be operating unusually, is making strange noises, has parts
missing or appears to be defective, stop using it immediately and arrange for repairs
by an authorized service center .
15.
CHECK SAFETY/pUSH LEVER BEFORE USE.
Make sure the safety/push lever operates properly . Never use the stapler unless the
safety/push lever is operating properly, otherwise the stapler could drive a fastener
unexpectedly . Do not tamper with or remove the safety/push lever, otherwise the
safety/push lever becomes inoperable .
16.
CHOICE OF TRIGGER METHOD IS IMpORTANT.
Read and understand section titled “Methods of Operation .”
17.
DO NOT USE OXYGEN, COMBUSTIBLE OR OTHER BOTTLED GASES.
EXpLOSION MAY OCCUR.
Never use oxygen, combustible gases or any other bottled gases as a power source
for the stapler . Use of these gases is dangerous, as the stapler will explode .
Use only clean, dry, regulated compressed air as a power source .
18.
DO NOT EXCEED 120 psi.
Do not exceed maximum recommended air pressure 120 psi . Never connect the
stapler to pressure which potentially exceeds 150 psi as the stapler can burst .
19.
NEVER USE IN pRESENCE OF FLAMMABLE LIQUIDS OR COMBUSTIBLES.
The stapler produces sparks during operation . Never use the stapler on sites
containing lacquer, paint, benzine, thinner, gasoline, gases, adhesive agents or other
materials which are combustible or explosive .
20.
KEEp ALL SCREWS AND COVERS MOUNTED TIGHTLY IN pLACE.
Keep all screws and covers tightly mounted . Check their condition periodically . Never
use the stapler if parts are missing or damaged .
21.
DO NOT USE THE WRONG FITTING ON STApLER .
The stapler and air hose must have a hose coupler so that all pressure is removed
from the stapler when the coupler is disconnected . The connector on the stapler must
not hold pressure when the air supply is disconnected . If the wrong fitting is used, the
stapler can remain charged with air after disconnecting and thus will be able to drive a
fastener even after the air line is disconnected, possibly causing injury .
