16 Ga. Wide Crown Stapler
Drives 15/16" Crown Staples (5/8" to 2" / 16 to 50mm)
Model No. SGSW5016
Item No. 64415
11
Interchange Brands
Operator’s Manual
COLD WEATHER CARE
Do not store the tool in a cold weather environment .
Keep the tool in a warm area until beginning the work .
If the tool is already cold, bring it in a warm area and
allow the tool to warm up before use .
1 . Reduce the air pressure to 60 to 80 psi
﹙4 .2 bar 4 .2 kgf/cm2﹚ .
2 . Remove all fasteners from the tool .
3 . Connect the air hose and free-fire ﹙blank-fire﹚ the tool .
The lowered air pressure will be enough to free-fire the
tool .
Slow speed operation tends to warm up the moving part .
OpERATION IN HOT WEATHER
Keep tool out of direct sunlight as excessive heat can
deteriorate bumpers, o-rings and other rubber parts
resulting in increased maintenance .
OpERATING THE TOOL
DRIVING DEpTH ADJUSTMENT
Depth drive adjustment allows user to drive staples
to the precise level on the surface.
WARNING:
Always disconnect air supply before
changing the adjustment dial .
ADJUSTING THE DEpTH
With air pressure set, drive staples into
a piece of scrap material to determine if
an adjustment is necessary .
If adjustment is required, disconnect air
supply .
To drive the staple shallower, turn the
wheel to the right to the extent desired .
To sink a staple deeper, turn the wheel
to the left to the extent desired .
Make sure that the trigger and
safety move freely up and down
without binding or sticking after each
adjustment .
Reconnect air supply .
Wheel to
adjust
depth of
drive
Deeper
Drive
Shallower
Drive
