I N S T A L L A T I O N M A N U A L
W I L D R I D E ™ S L I D E
7
WRS-IM Rev. 7/08 (SBK-INST WRS)
ASSEMBLY AND INSTALLATION INSTRUCTIONS
STEP ONE:
Measure the Pool
Using the slide placement information on pages 4 and 5, choose the location and position for
the slide. Next, measure the pool in front of where the slide will be installed and ensure it meets
the minimum water safety envelope and clearance requirements.
Inter-Fab highly recommends that only the fully assembled slide be utilized to mark the locations
for the anchor bolts.
Fig. 4
Fig. 5
Fig. 1
Fig. 2
Fig. 3
STEP TWO:
Assemble Flume Sections
TIP:
Use the anti-seize (provided) on all bolts to prevent hardware from seizing.
Align the bolt holes in the flume flanges, use vice grips or clamps to hold the flanges in place.
Using hardware kit SH-102-SS, in this order, take bolt, flat washer, push through both flanges,
flat washer, then nut. (See Fig. 1, Fig. 2, and Fig. 3)
Hand tighten only at this point.
STEP THREE:
Attach Legs to Flume
TIP:
Use the anti-seize (provided) on all bolts to prevent hardware from seizing.
The 2 longer legs attach to the upper flume section. The shortest leg attaches to the inside
curve of the lower flume. (See Fig. 5)
Using hardware kit SH-102-SS, slip leg over the leg receiver on the flume. Align the predrilled
holes, then in this order, take bolt, flat washer, push through leg and receiver, then flat washer,
then nut.
INTER-FAB WILD RIDE SLIDE MUST BE INSTALLED USING THE PROVIDED STEEL DECK
ANCHORS OR YOU WILL VOID THE WARRANTY.
