I N S T A L L A T I O N M A N U A L
W I L D R I D E ™ S L I D E
13
WRS-IM Rev. 7/08 (SBK-INST WRS)
Fig. 19
Minimum Concrete Pads – Wild Ride Slide
(Plan View – NOT to Scale)
Pool Edge
5 concrete pads are needed:
(1) 12” wide x 32” long x 12” deep
(4) 16” wide x 16” long x 12” deep
Center feet on pads
When installing an Inter-Fab Wild Ride™ slide using a paver kit, you must ensure that all standard
installation requirements are met. The slide must be compatible with the type of pool on the
intended installation and all ANSI/NSPI-2003 requirements must be met. Refer to installation
manual.
Figure 19 illustrates an example of the minimum concrete pads recommended for the and Wild Ride™
slides. Specific slide position and concrete pad orientations may vary. Make sure to allow for
water stub up location near the ladder section of the or Wild Ride™ slide when pouring the concrete
pad for the ladder section.
In order to ensure proper placement, you will need to set the slide up
first to determine where the concrete pillars will be located.
Figure 20 shows a side view illustration of the or Wild Ride™ slide foot deck anchor and wedge anchors
used in a paver installation. Pavers can be a maximum of 3” thick. Pavers must be mechanically
attached to the concrete pad using a setting material (such as mortar or thinset for example) that
is no thicker than 3/8”.
1” of each 3/8” x 7” wedge anchor (14 ea.) needs to be exposed above the final deck surface.
The 3/8” wedge anchors must be drilled to a depth of 6” with 1” of the bolt left remaining above
the final deck surface. The 3/8” x 7” wedge anchors (14 ea.) replace the 3/8” x 2-3/4” wedge
anchors (2 ea.) from hardware kit #SH-108 and the 3/8” x 2-3/4” wedge anchors (12 ea.) from
hardware kit #SH-106. You will need to factor in the thickness of your paver (3” MAX.) and the
thickness of your setting material (3/8” MAX.) for your individual installation.
You will need a 3/8” masonry bit for the or Wild Ride™ slide.
Inter-Fab Inc. will not be responsible for damage to pavers caused by drilling or mechanically
attaching to concrete pad. Refer to paver manufacturer’s specific installation instructions
before beginning.
Fig. 20
Example of Deck Anchor on Concrete Pad
(Side View)
CONCRETE
12” min.
Layer of setting
material to
secure pavers
to concrete.
PAVERS
3”
max.
Drawing Is
NOT To Scale
HEIGHT OF WEDGE
ANCHOR ABOVE
FINAL DECK
SURFACE
WEDGE
ANCHORS
16” min.
5” min.
from edge
PAVER KIT INFO – WILD RIDE SLIDE
