1.800.737.5386 • www.Inter-Fab.com
6
c.
Attach the actuator end fitting as shown on page 3 using:
1 -
3/8” Shoulder Bolt 1 ¼” x 5/16” - 18
1 -
3/8” Flat washers
1 -
5/16” - 18 Nylock nut
d.
Slide the battery down until it mates with the Wireless Receiver, and locks into place. When properly
installed the battery will sit flush against the top of the Wireless Receiver. The Control Box should
indicate a fully charged Battery (Green Light).
e.
Test lift operation by pushing the up and down toggle switch on the Wireless Receiver to ensure the lift is
operational (See page 8 for instructions on using Wireless Transmitter). Then run the actuator into the fully
extended position by pressing the up button until the actuator stops moving. Leave the lift in this position
for the next steps.
f.
Join the seat arm to the mast assembly using:
2 -
3/8” Shoulder 2 1/2” x 5/16” Thread
4 -
3/8” Flat washers
2 -
5/16” - 16 Nylock nut
4 - Donut Shims
