I N T E N S E C Y C L E S . c o m
// 1 1
11
10
13
12
C O n n e C T i n G C r O s s B r A C e T O r e A r T r i A n G L e //
A
Lift the Sniper top link up and
out of the way as shown above
(Image #10).
B
Set the crossbrace (#130874)
on the rear triangle at the top link
connection (Image #11).
C
Gently spread the rear triangle
pivots apart to allow the cross
brace to fit into position (Image
#12 and #13).
15
14
17
16
C O n n e C T i n G r e A r T r i A n G L e T O T O p L i n K / /
A
Put a small dab of grease on
the outside/inside bearing races
as well as on the contacting
surface of the bearing spacers
(#130832). Be sure to place a
greased bearing spacer on both
the outside and inside bearing
faces. You will use a total of 4
spacers for this step (Image #14).
B
Swing the rear triangle up to line
up pivot point with upper bearing
spacer (Image #15).
C
Insert clevis bolts (#130877/
130834) into drive side and non-
drive side seat stays. Tighten by
hand until snug. We will come
back with 6 mm hex torque wrench
(Image #16 and #17).
Summary of Contents for Sniper T
Page 1: ...user manual s n i p e r T...
