INSTALLATION SUMMARY
14
W-GV/2, W-GV/3, W-GV 8 and W-GV 10 —
March
2015 — EN
4
INSTALLATION SUMMARY
4.1
GENERAL
1
Mount the genverter directly, without additional vibration
dampers, on a solid surface.
2
If applicable, mount the separate cooling system.
3
Connect exhaust system.
4
Connect ‘fuel supply line’ to the water separator/ fuel
filter.
5
Connect ‘fuel return line’ to the fuel tank.
6
Connect remote panel (just plug in).
7
Connect the AC cables to the PMG/DC PowerCube.
8
Connect the battery cables to the 12V starter battery’s
positive and negative terminals.
9
If applicable, connect the power supply of the external
radiator.
10 Install a WhisperPower battery charger (optional).
4.2
COMMISSIONING TABLE
1
Check if the air inlet is sufficient.
2
Check if the cooling system for the engine is properly
installed and properly filled with G12+ cooling liquid.
When the internal radiator is used ; check if the air flow is
not blocked and that no hot air is sucked back into the
sound shield.
3
Check if the exhaust system is properly installed. Check
maximum length of exhaust hose, diameter of exhaust
piping.
4
Check all coolant connections.
5
Check the AC cables and the grounding.
6
If the genverter is installed with a WP-PMG, check if an AC
breaker is installed before or after the power source
selector. When there is only a circuit breaker, use it to
disconnect the generating set from the grid.
7
Check all DC connections, check if the battery switch/
circuit breaker is closed.
8
Open the fuel valve. Check if there are no air leaks in the
fuel supply line, and check if the lift of the fuel is less than
1 m. Check if there is no air in the water fuel separator.
9
Check the oil level and color of the oil.
10 To bleed the fuel system, push the “Start” button on the
local control (not on the remote panel) and hold at least
5 s and as long as necessary to bleed the system.
11 Start the engine by pushing the start button.
12 If the genverter is installed with a WP-PMG, check the
delay of 5 to 10 seconds in the power source selector
transfer.
13 Check voltage under ‘no load’ conditions.
14 Check if the genverter can bring the full load.
15 Check if the battery charger of the genverter is working
(max. 14.5 V).
16 Close the sound shield and check the noise level.
17 Stop the genverter and check the engine again for leakages
of oil, fuel or coolant and check the oil level again.
Installation
checklist
available
on
our
website:
www.whisperpower.com.
Commissioning
form
available
on
our
website:
www.whisperpower.com
.
4.3
TECHNICAL DATA
Refer to the User’s Manual for an overview of general technical
specifications.
4.4
SPECIFICATION OF THE ACCESSOIRIES
Fuel filter/water separator
30 micron
Fuel inlet and return
8 mm
Flexible Exhaust bellow/ hose
1”G
Exhaust piping
1”
Exhaust mufflers
1”G
Starter battery
80 Ah
Summary of Contents for W-GV/2
Page 20: ...Ref PM WP GV8 Date 5 8 2016...
