Intellitec MT418L BT418, Instruction

Page: 10 / 24

Install the battery
Mount the battery
under the battery
strap.
Use the clips to
secure the battery
strap.
Starting up
A) Turn on the power to transmitter first
B) Connect battery and ESC
C) Power up ESC
D) Check steering, forward and reverse
E) You are now ready to go!
After driving
A) Turn off power to ESC
B) Disconnect battery and ESC
C) Turn off transmitter
D) Inspect the model and if needed tighten screws and
do cleaning.
LED
Matching line
Receiver
Battery
EN
2,4GHz radio for Brushless version
1. Control box
2. 2,4GHz antenna
3. Steering wheel
4. Throttle trigger
5. Battery box
6. Steering reverse
7. Power LED
8. Steering trim
9. Power switch
A. Throttle reverse
B. Power check
C. Bind
D. Dual Rate
E. Throttle trim
F. Charging input
G. DSC for simulator
Intellitec 1/18 models comes with this radio. The radio is easy to handle and has several functions to trim the model to
suite your driving style.
This step is already done from the factory and does not need to be done before driving.
If you for some reason need to re-bind the radio with receiver, follow these steps:
A) Mount batteries in the radio and have it powered off.
B) Insert the matching lines to the channel BIND/CH3 port of the receiver.
C) Connect the receiver battery to VCC port of the receiver and two LED are flashing which
means the receiver is put in binding mode.
D) Press the binding button on the radio and power it up.
E) Note the LED on receiver. If the LED have stopped flashing within
5 seconds the binding was successful.
F) Remove the matching line from receiver.
G) Connect a servo to the receiver and test the function.
H) If process fails - repeat step A-F.
Bind radio with receiver