57
Parameter
Description
Enable Static Routing
Select to enable the function (it’s disabled by default).
Destination LAN IP
Enter the network address of the destination LAN.
Subnet Mask
Enter the subnet mask of the destination LAN.
Default Gateway
Enter the next stop gateway of the path toward the
destination LAN. This is the IP of the neighbor router
that this router should communicate with on the path
to the destination LAN.
Hop Count
Enter the number of hops (routers) to pass through to
reach the destination LAN.
Interface
Select the interface that goes to the next hop (router).
Add a Rule
Fill in the "Destination LAN IP," "Subnet Mask,”
“Default Gateway,” "Hop Count" and "Interface" of the
rule to be added and click "Add." This rule will then be
added into the Static Routing Table below. To change
or correct an entry before adding it, click "Reset" to
clear the fields, then re-enter.
Remove a Rule
To remove some routing rules from the Static Routing
Table, select the rules in the table and click "Delete
Selected." To remove all rules from the table, click
"Delete All." Click "Reset" to clear current selections.
Click “Apply” at the bottom of the screen to save the above configurations. You
can now configure other sections or start using the router.
