Connecting the MIDI 1U to a 7U Case
You will need to connect the MIDI 1U to either a MIDI IN Jacks 1U module or to a case with built-in
MIDI/USB jacks. This section shows how to connect the MIDI 1U to the MIDI/USB jacks on an
Intellijel 7U case.
1.
Turn off power to the case.
2.
Connect the supplied 10-pin-to-16-pin power cable between the MIDI 1U and one of the Case’s
16-pin power connectors (as discussed previously).
3.
Connect one end of the supplied 10-pin to 10-pin ribbon cable to the shrouded 10-pin port on
the MIDI 1U module. The connector is keyed, and will fit in only one direction.
4.
Connect the other end of the cable to the MIDI Jacks circuit board on your 7U case. On newer
7U cases, this connector is shrouded (ensuring the cable fits in only one orientation). On older
cases, the connector is not shrouded, so pay particular attention to the orientation (aligning the
red wire with the white stripe on the circuit board).
5.
Power on the 7U Case.
The MIDI 1U module will now receive MIDI from the 7U case’s MIDI IN jacks (both USB and
5-pin MIDI) and convert it to CV. In addition, the 7U case’s MIDI OUT jack will function as a
MIDI Thru — passing along any MIDI data received at its MIDI IN jack.
MIDI 1U System Manual
8
