Dual Mode Configuration (Synth 1 + Synth 2)
MIDI 1U offers an alternate, dual channel mode that reconfigures its output jacks for dual synth
operation. In this mode, you control both
synth 1
and
synth 2
from the MIDI 1U module, giving you
independent MIDI control of the pitch, gate and velocity for two different MIDI channels (repurposing
the
MOD
,
CC
and
TRIG
jacks for
PITCH
,
VEL
and
GATE
jacks, respectively, for
synth 2
).
NOTE: You will need to configure any desired CLK division before entering Dual Mode.
To enter Dual Mode:
1.
Long press (>2 sec) the
LEARN
button.
MIDI 1U reconfigures as a dual channel device,
and the jacks take on the functions indicated in
the graphic to the right.
The
LEARN
buttons glow
yellow
, indicating the
device is in Dual Mode.
To learn MIDI Channels:
1.
Press the
LEARN
button to prepare for learning
synth 1’s
MIDI Channel.
The
LEARN
button will turn
red
.
2.
Send any channel-based MIDI message into the
MIDI 1U.
Synth 1
automatically sets itself to the sent message’s MIDI channel.
3.
Press the
LEARN
button again to prepare for learning synth 2’s MIDI Channel.
The
LEARN
button will
flash red
.
4.
Send any channel-based MIDI message into the MIDI 1U.
Synth 2
automatically sets itself to the sent message’s MIDI channel; the
LEARN
button will
stop flashing; and the unit will return to Dual Mode (i.e. the
LEARN
button is lit
yellow
).
NOTE: MIDI 1U will automatically save any new configuration after 2 seconds of MIDI activity
( CLK
÷
button flashes
green
), ensuring it returns to exactly the same state after a power cycle.
To exit Dual Mode:
1.
If MIDI 1U is currently in Dual Mode (
LEARN
button is lit
yellow
), long press (>2 sec) the
LEARN
button to revert to Normal Mode.
MIDI 1U reconfigures back to controlling a single (
synth 1
) device, and restores the
MOD
,
CC
and
TRIG
settings to their previously programmed conditions.
MIDI 1U System Manual
21
