Intellijel MIDI1U, Manual

Page: 37 / 42

Trigger The jack outputs a +5V trigger signal whenever a MIDI
Note On message is received on the
MIDI Channel used
by the selected Synth. By default, the Trigger length is
5ms, but you can override this, per-synth, using the
Trigger Length option in the Synths Column .
Velocity The jack outputs a velocity value with a range of 0-5V. The
voltage is proportional to the MIDI velocity received on the
MIDI Channel used by the selected Synth.
Clock Division NOTE: Available only if Output Type = “Clock (Always)” or
“Clock (Running)”
Selects a clock division to apply to the incoming MIDI
clock.
/1 clock out = 24 ppq
/3 clock out = 1/32 notes
/6 clock out = 1/16 notes
/12 clock out = 1/8 notes
/24 clock out = 1/4 notes
/48 clock out = 1/2 notes
/96 clock out = whole notes
Synth NOTE: Not available if Output Type = “Clock (Always),”
“Clock (Running),” “Reset” or “Run”
(1 - 10) Selects which Synth (1 - 10) is the source of that jack’s
output voltage. The
Type of synth (as selected in the
Synths Column ) is also indicated. The output voltage
present at this jack is derived from whichever incoming
MIDI channel is assigned to that Synth (also selected in
the Synths Column).
CC Number NOTE: Available only if Output Type = “CC Number” or
“CC Number (High Res)”
(0 - 95) Selects which MIDI CC# is the source of the control
voltage sent out the jack. For example, if you select
5 Portamento Time
, then the jack will transmit a control
voltage based on CC #5 data on the MIDI Channel used
by the selected Synth.
NOTE: Not every value between 0 and 95 is available.
Those that aren’t are greyed out. Note also, that if the
Output Type = CC Number (High Res) , then fewer CC
sources are available than if Output Type = CC Number .
MIDI 1U System Manual 36