Connecting Harnessing
Engage® Zone Control Installation Manual
600840-000043, rev 1.4
Page 24 of 31
3. Connecting Harnessing
Route harnessing along existing harnesses where possible. Otherwise, avoid pinch points and
allow for an adequate amount of harness slack at the implement and air cart pivot points.
Refer
to Appendix A for full wiring diagrams.
Part name
Part number
Quantity
needed
Contained
within
Sealing plug (optional)
153510-000091
1
Accessory
Work switch extension harness
353050-000011
1
System kit
Gateway harness
353050-000032
1
System kit
Tractor harness
353050-000034
1
System kit
Intermediary harness (optional)
353050-000035
1
Accessory
Diagnostic adapter harness (optional)
353050-000047
1
Accessory
Bin harness
353050-000060
1
System kit
Cable tie
355032-000004
varies
System kit
12 pin dust cap
356070-000072
1
System kit
3.1. Installing Tractor Harness
1. Unplug the current ISOBUS harness. Connect S1 of the tractor harness (353050-
000034) to the tractor’s ISOBUS outlet.
2. Connect S2 of the tractor harness to the ISOBUS harness that you just unplugged.
3.
Tow-between air cart:
Connect S3 and S4 of the tractor harness to S5 and S1 of the
gateway harness (353050-000032).
Tow-behind air cart:
Connect S3 and S4 of the tractor harness to S1 and S2 of the
Intermediary harness (353050-000035). Then, connect S3 and S4 of the Intermediary
harness to S5 and S1 of the gateway harness.
