IM483H/IM805H Rev. R032206
14
15
IM483H/IM805H Rev. R032206
Recommended Solder
Recommended Cleaning Solvent
Kester “245” No Clean
Tech Spray “Envirotech 1679”
Alpha Metals “Telecore Plus”
Chemtronics “Flux-off NR 2000”
Multicore “X39B” No Clean
Figure 3.3: PCB Hole Pattern (for Mounting of the PR-22 Pin Receptacle Carrier)
Mounting the IM483H/IM805H Using the PR-22
Receptacle
The PR-22 pin receptacle carrier allows
for easy placement of multi-fingered
receptacle pins facilitating easy removal
and placement of the IM483H/IM805H
driver. The PR-22 is a disposable plastic
frame containing 23 receptacles in a
layout that matches the pin layout of the
IM483H/IM805H hybrid.
This tool enables the user to insert the
23 receptacles into their PC board design
in a single operation for wave or hand
solder. The plastic frame can then be
lifted out and discarded. The following
figure (
Figure 3.3
) shows the PCB hole pattern and recommended pad size that should be
used on the end-user PC board. The recommended mounting hardware are the same as
illustrated in Figure 3.4.
To lift the disposable carrier after soldering, gently pry the carrier from the PCB with a
flat head screwdriver or, to avoid chancing PC board damage, use the optional pry bar
(PB-22).
0.200"
(5.08)
0.100"
(2.54)
0.375
(9.5)
0.525”
(13.30)
2.350"
(59.70)
0.720
(18.3)
0.780
(19.8)
0.166 (4.2) DIA. HOLE
2 PLACES
0.107 (2.72) DIA. HOLE
0.156 (3.96) WIDE PAD
0.176 (4.47) LONG PAD
9 PLACES
0.062 (1.57) DIA. HOLE
0.090 (2.29) WIDE PAD
0.110 (2.79) LONG PAD
14 PLACES
Figure 3.2: PR-22 Pin Receptacle Carrier
