IM483H/IM805H Rev. R032206
14
15
IM483H/IM805H Rev. R032206
S e c t i o n 3
M o u n t i n g t h e I M 4 8 3 H / I M 8 0 5 H
S e c t i o n O v e r v i e w
This section covers mounting the IM483H/IM805H in your system. The fol-
lowing mounting options are covered:
n
Mounting the IM483H/IM805H to a PCB.
n
Mounting the IM483H/IM805H using the PR-22 Pin Re-
ceptacle.
n
Recommended Mounting Hardware.
n
Attaching/Removing the HFC-22 Heat Sink/Fan/Clip As-
sembly.
M o u n t i n g t h e I M 4 8 3 H / I M 8 0 5 H
The IM483H & IM805H hybrids are designed to be soldered into the users PC
board, however, they may also be mounted using the PR-22 pin receptacle car-
rier for ease of removal.
D i r e c t M o u n t i n g t h e I M 4 8 3 H / I M 8 0 5 H t o a P C
B o a r d
The IM483H and IM805H hybrids are designed to be soldered directly into a PC board.
The following diagram contains the hole pattern and recommended pad sizes for direct
mounting of the IM483H/IM805H.
Recommended Soldering Practices
Max. Soldering Temp .................................................................... 315°C
Max. Soldering Time .....................................................................10 sec.
Figure 3.1: PCB Hole Pattern (Direct Mounting of the IM483H/IM805H to a PC Board)
0.200
(5.08)
0.100
(2.54)
0.375
(9.5)
0.525
(13.30)
2.350
(59.70)
0.720
(18.3)
0.780
(19.8)
0.166 (4.2) DIA. HOLE
2 PLACES
0.70 (1.80) DIA. HOLE
0.150 (3.80) DIA. PAD
9 PLACES
0.042 (1.00) DIA. HOLE
0.075 (1.90) DIA. PAD
14 PLACES
