v100Ka – Marine Satellite Communication System
14
System Configuration
For your satellite communication system to work properly, the system will have to
be connected with all of the provided components as shown in the figure below.
A separate purchase of a satellite modem, ship’s gyrocompass, and Intellian Dual
VSAT Mediator may be required.
1) Connect an RF cable from the antenna to
Antenna RX
port at the ACU.
2) Connect an RF cable from the antenna to
Tx Out
port at the modem.
3) Connect an RF cable from
Modem Rx
port at the ACU to
Rx In
port at the modem.
4) Connect a LAN cable from Ethernet port at the ACU to RJ45 connector 1 at the modem.
5) Connect the supplied BUC interface cable (Type: D-sub to RJ45) from
BUC Interface
(D-sub) port at the ACU to BUC I/O (RJ45) port at the modem.
6) Connect a ship's gyrocompass to NMEA port at the ACU.
7) Supply ship's power to the system.
Basic system
configuration
AC 100 ~ 240VC
(50~60Hz, 4A)
AC 100 ~ 240VC
(50~60Hz, 1A)
Ship’s Gyrocompass
(Not supplied)
NMEA
Modem Interface
PC Interface
BUC Interface
Modem Rx
Antenna Rx
Modem Tx
iDirect X7 Modem
(Not supplied)
Antenna Control Unit
