Intelix
DIGI-HD-4X8
Installation Manual
16
www.intelix.com
Ethernet Remote Control
The DIGI-HD-4X8 supports remote control through a rear panel Ethernet port.
The matrix accepts control messages when connected to a local area network
(LAN).
1.
If controlling the DIGI-HD-4X8 through the Ethernet control port on the
rear panel, connect an Ethernet cable directly to the matrix.
2.
Connect the opposite end of the Ethernet cable to a LAN port. Within 10
seconds of connecting the DIGI-HD-4X8 to the LAN, the yellow LED on
the matrix’s Ethernet port will stop blinking and the green LED will blink
intermittently.
Controlling the Matrix over a LAN
Intelix provides a diagnostic software utility, NetFinder, to determine the IP
address of the DIGI-HD-4X8. Please visit Intelix’s online technical library to
download the latest version of the software:
http://www.intelix.com/tech_library/software.htm.
1.
Download and install
NetFinder
on your computer.
2.
Launch the utility.
Note:
The DIGI-HD-4X8 will automatically be assigned an IP
address when connected to a DHCP-enabled network.
Connection Troubleshooting:
If the matrix does not respond with
a green LED, please follow the steps below:
-
Verify the LAN has DHCP support.
-
Verify the LAN port is active.
-
If you continue to have issues getting the matrix to connect
to the LAN, verify LAN connectivity using a PC. If you
can not get a PC to connect, contact a network
administrator for assistance
