Intelimax MA-2060, User Manual

Page: 49 / 50

Intelimax LITE User Manual V1.02
- 49 -
Initiate a Data Call
Command TE2 
MT2
Command TE2 
MT2
ATD<phone_number>
Notify TE2

MT2
CONNECT (Data call connected)
Connect <Speed> if connect_baud is set.
NO CARRIER (Data call failure)
Value
phone_number:
for Packet Switched Data: *99# (Australia – requires authentication)
for Circuit Switched Data: You will need a data number ( Code 2620
activated on the SIM account)
Answer an Incoming Data Call
Notify TE2

MT2
AT: RING
Command TE2 
MT2
ATA (answer data call)
Notify TE2 
MT2
CONNECT (Data call connected)
CONNECT <SPEED> if connect baud is enabled.
NO CARRIER (Data call failure)
Call State
Command TE2

MT2
+++ (escape command to go to on-line command
state)
ATH (release call)
Notify TE2 
MT2
NO CARRIER
Save & Reboot
AT&W
Saves AT commands
AT%RESET=1
Applies saved AT commands with a reboot in Serial Modem mode
Periodic Reset
at$$preset=2
OK
at$$preset?
$$PRESET: 2