Cedar 880AG Enterprise Dual-Radio AP/Bridge
Mode:
DHCP
: If DHCP is chosen, a dynamic IP address is assigned to AP by the DHCP
Server. In addition, the subnet mask, default gateway and DNS server addresses are
also assigned. Because DHCP assigns the IP address dynamically, different IP
addresses may be assigned to the AP after each reboot.
Static
: In order to have full control of the IP address, the administrator may choose
to use the Static IP. If Static mode is chosen, the administrator assigns the static IP
address, subnet mask, default gateway and DNS server address for the AP. The AP
will always have the same IP address after each reboot.
IP address
For DHCP mode: The DHCP Server assigns a dynamic IP address to the AP.
For Static mode: Enter the static IP address for the AP.
Netmask
For DHCP mode: The DHCP Server assigns a network mask to the AP.
For Static mode: Enter the network mask for the AP.
Gateway
For DHCP mode: The DHCP Server assigns a default gateway to the AP.
For Static mode: Enter the default gateway for the AP.
Management VLAN ID
By default, VLAN support is disabled. All packets sent by the AP are
untagged
. To
enable VLAN support, click
tagged
and enter a VID value between 0 and 4095.
Before enabling VLAN support, the VLAN setting needs to be pre-configured on a
VLAN-aware switch, such as the Intelicis Cypress 1024.
30