10
8. Low battery sensor
The IVP 1000 Pet SF sensor controls the battery level and if it is critical (equal to or below 2.5V) it sends the information to
the control panel during triggering. In addition, the sensor also signals through the LED, after each activation of the sensor
the LED lights up (as usual) and then flashes indicating low battery.
Use only quality batteries with the correct sizing for the device, and with typical use of the device, the expected battery life
is 1 to 2 years, which may be influenced by the number of activations, weather conditions and mode of settings. The battery
model must be CR123A 3V, using one (1) battery per sensor.
9. Battery replacement
To replace the product’s battery:
» Remove the dead battery;
» Press the
PROG button or wait a few seconds for the circuit to completely discharge;
» Connect new battery.
10. Homologation
18969-21-00160
This equipment is not entitled to protection against harmful interference and may not cause interference in properly
authorized systems. This is a product approved by Anatel, the approval number can be found on the product label, for
queries go to the website:
sistemas.anatel.gov.br/sch.
