9
3. Installation
1. For security reasons, it is necessary to open the sensors to identify which is the transmitter and which is the receiver.
Here’s how to open the sensor cabinet and perform the necessary identification:
5
4
3
2
1
TEMPO
RESPOSTA
-
+
5
3
1
-
+
IVA 5080 AT
IVA 5040 AT
Identificação TX e RX
Remova o parafuso
Remova a tampa frontal
conforme movimento indicado
na figura, utilize abertura localizada
na parte inferior da tampa frontal
para facilitar a remoção
Remove the screw
TX and RX identification
IVA 5040 AT
IVA 5080 AT
Remove the front cover as shown in the
figure, use the opening located at the
bottom of the front cover to facilitate
removal
2. After identification, run the cable as shown in the following image to connect it to the terminal block:
Vista posterior
Vista lateral
Cabo
Rear view
Side view
Cable
