Intel SBXD62 - Server Compute Blade, Installation And User Manual

Page: 41 / 118

Intel® Server Compute Blade SBXD62 Installation and User’s Guide 31
Installing the Blade Server Bezel Assembly
See the illustration in “Removing the Blade Server Bezel Assembly” on page 19 for
information about installing the bezel assembly.
To install the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page 65 in Appendix C, “Safety
Information” and “Installation Guidelines” on page 15 .
2. Connect the control-panel cable to the control-panel connector on the system board.
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.
Closing the Blade Server Cover
Important: The blade server cannot be inserted into the Intel® Blade Server Chassis SBCE until the
cover is installed and closed or an expansion unit is installed. Do not attempt to override
this protection.
The following illustration shows how to close the blade server cover.
To close the blade server cover, complete the following steps:
1. Read the safety information beginning on page 65 in Appendix C, “Safety
Information” and “Installation Guidelines” on page 15 .
2. If you removed the blade bezel assembly, replace it now (see “Installing the Blade
Server Bezel Assembly” on page 31 for instructions).
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear of the
blade server, as shown in the illustration. Before closing the cover, check that all
components are installed and seated correctly and that you have not left loose tools or
parts inside the blade server.
4. Pivot the cover to the closed position, as shown in the illustration, until it clicks into
place.
AF000437
Blade-Cover
Release
Cover
Pins
Blade-Cover
Release